The ModelSource 640-pin Adapter

Chapter 2: Building the Daughterboard

Fourteen #4 lock washers

Fourteen #4 flat washers

One EEProm, Catalyst semiconductor CAT93C86.

Note

The above does not include the package type designation; that is up to the model designer.

Two Synopsys board stiffeners (short), 600-00193 (or build according to specifications).

Two Synopsys board stiffeners (long), 600-00XXX (or build according to specifications).

Figure 3 shows a drawing of the short and long board stiffeners.

Short Stiffener

Long Stiffener

Figure 3: Fabrication Drawing of Board Stiffeners

Requirements

You must locate the connectors and guide pin holes exactly as shown in Figure 1 on page 12, so that the Daughterboard will fit onto the Adapter.

The height of the DUT above the Daughterboard must not exceed 2.25 inches.

November 2001

Synopsys, Inc.

15

Page 15
Image 15
Synopsys 640-pin Generic Device Adapter manual Requirements, Shows a drawing of the short and long board stiffeners