The ModelSource | Chapter 3: Connecting the Daughterboard |
Procedures
Caution
Do not connect or disconnect the Daughterboard to or from the Adapter while the Adapter is mounted on the ModelSource modeling systems.
To connect the Daughterboard to the Adapter, follow these steps:
1.Remove the lid from the Adapter.
2.Set the Daughterboard on the Adapter, engaging the guide pins through the guide pin holes.
3.Push firmly to seat.
4.
5.Replace the Adapter lid.
To disconnect the Daughterboard from the Adapter, follow these steps:
1.Remove the lid from the Adapter.
2.Loosen the Southco retractable screw fasteners.
3.Push the ejectors on the Adapter.
4.Carefully lift the Daughterboard from the Adapter.
5.Replace the Adapter lid.
November 2001 | Synopsys, Inc. | 21 |
