TANDBERG ENTRYPOINT manual Configuration pane, Authentication Mode is Off or Auto

H.323 Configuration

TANDBERG ENTRYPOINT USER GUIDE

Select H.323 to access the

H.323 Configuration pane.

When registered with

a gatekeeper, the H.323 Status shows

Registered, the gatekeeper’s IP address and the Port used (see also Status, H.323 Status).

Dialling out from IP to

IP or ISDN, through the Entrypoint,

requires the use of H.323 numbers (E.164 aliases and service prefixes). This means that the Entrypoint must be registered to a gatekeeper; select the H.323 menu item in the Configuration menu.

Save. When ready to store the new settings, press Save.

In case password is not set/configured/inserted, the Entrypoint will still

use the Authentication ID to register with the gatekeeper. However, when the Authentica- tion ID is left “unused”, the System Name field. will be used to register the Entrypoint with the gatekeeper instead. In case both the Authentication ID field and the System Name field are “unused” the Entrypoint can not be registered with the gatekeeper.

Table of	Trademarks	&	Patents &	Safety/	To	Get You	Using the	Viewing the		Configuring
Contents	Copyright		Disclaimers	Environmental	Up	and Going	Entrypoint	System Status	the	Entrypoint
								33
D 14050.04
10.2007

Mode. Enables the Entrypoint to register with a gatekeeper or leave it unregistered, i.e. in direct mode. Make sure that System Name is always set in direct mode. When registered with a gatekeeper, the H.323 Status shows Registered, the gatekeeper’s IP address and the Port used.

When the registration fails, the Registration status will be rejected. Three cases can be distinguished:

•Gatekeeper unreachable; the Entrypoint’s H.323 stack returns this reject message in case the gatekeeper is down.

•Duplicate alias; a system with an identical name has already been registered.

•Authentication failure; Authentication ID and/or Authentication Password are incorrect.

Selecting direct mode will result in no gatekeeper registration; hence it is not possible to dial through the Entrypoint via alias names. The H.323 Status shows Inactive.

IP Address. Enter the Gatekeeper IP address that the Entrypoint should register to. Leaving this empty will result in direct dialling without the use of aliases.

Authentication Mode is Off or Auto.

•Off. Register to the Gatekeeper without authentication.

•Auto. Register to the Gatekeeper with H.235 authentication using ID/Password given below.

Authentication ID and Password. Enter the ID and pass- word required to perform H.235 authentication at the Gatekeeper. To register with a Gatekeeper that requires authentication, an NTP server has to be configured.

If the Gatekeeper is configured with an alternative Gatekeeper, the Status area may report a registration to the IP address

of the alternative Gatekeeper.
Maintenance	Services	Dial Plan	Contact
& Upgrade		Examples	Information