Configuring Your Entrypoint via the RS 232
TANDBERG ENTRYPOINT USER GUIDE
About Gateway Configuration
The Entrypoint requires some basic configurations before it can be used. It will be necessary to find the
Configuring via the RS 232
Make sure the Entrypoint is Off and | | Switch on the Entrypoint. | Start a terminal program on the PC and |
connect an RS232 cable between the |
| configure it to: | |
Entrypoint and a PC. |
|
| 115200, 8, 1, None |
|
|
| |
|
|
| Power switch |
Configuration via the Front Panel
As an alternative to the configuration via RS 232 you may use the LCD panel to configure and check the IP settings, as well as to reboot the system. This is outlined on the next page.
To assign a static
Xconf ip Assigment: “Static” and
Xconf ip address <IPAddr>
To assign an IP Subnetmask, type Xconf ip address subnetmask <subnetmask>
Restart the Entrypoint. | Start a WEB browser |
| and enter the |
| |
| Entrypoint. Default |
| password: TANDBERG |
| Note the case sensitivity! |
To configure the Entrypoint for UMTS
To assign an IP Gateway address, type Xconf ip address gateway <gateway
To configure the Entrypoint for IP dial in, register the Entrypoint to a Gatekeeper and enter H.323 services. For details, see Configuring the Entrypoint
