Connecting the IP GW
Before you start
IMPORTANT: Before installing the IP GW, you must read the safety
information at http://www.codian.com/safety.htm
Step one: Connect power
Connect the power connector on the rear of the unit to the power supply using the supplied power cable. (There is no On/Off switch.)
Connecting power causes the Power LED to light blue and when the IP GW has booted (which can take up to two minutes), the Status LED will light green.
Step two: Connect to Ethernet Ports A and B
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a hub, to minimize interference from other devices on the network). The Ethernet port is a 10/100/1000 Mbps
Connect Port A to your local network and connect Port B to a second subnet or the internet depending on your application of the IP GW.
!Do not connect Ethernet Port A and Ethernet Port B to the same subnet.
4
