Introduction
Page 1-6 Reference Guide: TT128x High Definition Professional Receiver/Decoder
ST.RE.E10141.5
BPSK/QPSK/8PSK/16QAM (HOM) L-Band Inputs (Satellite
Receivers) (Option)
Four F-type connectors connect the L-band output of a suitable LNB either
directly or via a suitable attenuator giving lightning and surge protection.
DVB-S QPSK, DVB-S2 QPSK, 8PSK Input (Satellite
Receivers)(Option)
Four F-type connectors (TT1280/HWO/DVBS2) or Three F-type connectors
+ IF Inputs + Constellation output (TT1280/HWO/DVBS2/IF/CONST).
Connect the L-Band output of a suitable LNB either directly or via a
suitable attenuator giving lightning and surge protection.
TTV G.703 DS3 and E3 Input (Telco Receivers) (Option)
Equipped with a single BNC connector for receiving signals over a PDH
Telco network.
IP Input (Telco Receivers) (Option)
A single 10/100BaseT RJ-45 connector for receiving signals over Ethernet.
Frame Synchronisation
A BNC connector accepts a composite video input to which the video
output timing can be synchronised.
1.2.3 Outputs Transport Stream Outputs
• Two BNC connectors output ASI Transport Streams with a maximum
data rate of 160 Mbit/s, depending on the CA in use and the input card
front-end.
Video Outputs
• One SVGA HD video output carried on a D-type connector.
• Two digital video outputs carried on BNC connectors.
Audio Outputs
• Two 9-way D-type, male connectors decode two PES streams of audio
from the Transport Stream. The audio outputs simultaneous analogue
and digital. The digital mode can be changed via the user interface.
Data Output
• RS-232 asynchronous low-speed data output carried on a 9-way,
D-type, female connector.
• RJ-45 high-speed data over Ethernet output (option).
• RS-422 synchronous high-speed data output carried on a 9-way
D-type, female connector.
Alarm Output
A 9-way, D-type connector for interfacing to the alarm and failure
monitoring within the equipment. This includes a summary alarm signal
that coincides with the general front-panel ALARM LED.