Tandberg Data Configuring and Operating the Tandberg DLT4000 Drive
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB
3-10 Tandberg DLT4000 Installation Guide
7DEOHVKRZVWKHUHVXOWVRIGHQVLW\VHOHFWLRQ
If …Then …
The Density Select button is not
used The indicators show the actual density when
the tape is reading and writing. The indicators
are on steady and Density Override is off.
The Density Select button is
used, and if the actual tape
density is the same as the
density you selected
The actual density and the Density Override
light. For example, if the actual tape density is
10.0 GB and the selected tape density is 10.0
GB, then the indicator next to 10.0/15.0 lights.
The Density Select button is
used, and if the actual tape
density differs from the density
selected
1. The indicator with the actual density is on
steady
2. The indicator with the selected density
blinks
3. Density Override lights steady
For example, if the actual tape density is 10.0
GB and the selected density is 6.0 GB,
10.0/15.0 lights steady, 6.0 blinks, and
Density Override indicator is on steady.
7DEOH5HVXOWVRI'HQVLW\6HOHFWLRQ
7RVHOHFWGHQVLW\RYHUWKH6&6,EXV
 'RD 6&6, 02'( 6(/(&7 ZLWK WKH GHQVLW\ \RX
ZDQW
 :ULWHGDWDWRWKHWDSHIURP%27