Tandberg Data DLT4000 manual - page 4

3. Configuring and Operating the
Tandberg DLT4000 Drive 3-1
3.1. This Chapter 1
3.2. Before You Install the Tandberg
DLT4000 Drive 1
3.2.1. Disabling Parity Checking
(Default = Enabled) 2
3.2.2. Changing the SCSI ID 5
3.2.3. Setting the TRM PWR (Single-
ended Only) Jumper (Default =
Disabled) 5
3.2.4. Locating the SCSI Cable and
Power Connectors 6
3.3. Overview of the Front Panel 7
3.4. Selecting Density 8
3.5. Description of Controls and
Indicators 11
3.5.1. Beeper 11
3.5.2. Unload Button 11
3.5.3. Cartridge Insert/Release Handle 11
3.5.4. Indicator Action during Power-
On Selftest and Operation 12
3.6. Description of the Tape Cartridge 16
3.6.1. Cartridge Write-Protect Switch 16
3.6.2. Data Protection 18
3.7. Loading a Cartridge 19
3.7.1. Tape in Use 21
3.8. Using the Cleaning Tape Cartridge
(Tandberg Data Cleaning Cartridge
P/N 43 18 78) 22
3.9. Unloading a Cartridge 23
3.10. Preserving Cartridges 25
3.11. Firmware Update Procedure 26
3.11.1. Updating the Firmware on the
Tandberg DLT4000 Drive (Drive
Only Configuration) 27
3.11.1.1. Interpreting the Results
(Tandberg DLT4000 Code
Update) 29