Tandberg Data Configuring and Operating the Tandberg DLT4000 Drive
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB

3-22 Tandberg DLT4000 Installation Guide

3.8. Using the Cleaning TapeCartridge (Tandberg DataCleaning Cartridge P/N43 18 78)

8VH7DEOHWRGHWHUPLQH

If …It means …And you should …
1. Use Cleaning Tape
indicators
(Figure 3-6)
The drive head needs
cleaning or the tape
is bad (see item 3)
Use the cleaning cartridge.
Follow the instructions in
Section 3.7. for loading a
cartridge into the drive. When
cleaning completes, the Use
Cleaning Tape indicator shuts
off and the beeper sounds for
you to remove the cleaning
cartridge.
2. A data cartridge
causes Use
Cleaning Tape to
blink
The data cartridge
may be damaged Back up this data onto another
cartridge. Discard the old car-
tridge, which may be damaged.
A damaged cartridge may
cause unnecessary use of the
cleaning cartridge.
3. Use Cleaning Tape
still indicators after
you clean the drive
head
Your data cartridge
may be causing the
problem
Try another data cartridge.
4. Use Cleaning Tape
indicators after you
load the cleaning
cartridge
Cleaning has not
been done and the
cartridge is expired
Replace the cleaning cartridge.

7DEOH:KHQWR8VHWKH&OHDQLQJ&DUWULGJH

127(
7KHFOHDQLQJFDUWULGJHH[SLUHVDIWHUDERXWXVHV