BASIC OPERATIONS

Playing from an Intermediate Point in a Tune

To search for any intermediate point in a tune and play back the final take from that point, select the track at step 3 in procedure on the previous page, and perform the following.

4Press the PLAY/PAUSE key to perform monitor playback, and proceed to near the desired point.

5Press the PLAY/PAUSE key near the desired point to set to the monitor PAUSE mode.

6Search the desired point using the SEARCH key.

[NOTE]

One light touch of the SEARCH key in the monitor PAUSE mode moves the point forwards or backwards in single-frame units. Holding down the SEARCH key increases the search speed. (→ page 16 “Searching for an Intermediate Point in a Tune”)

7When the desired point is found, press the PLAY/PAUSE key again to perform monitor playback, and confirm the point.

8Press the READY key.

The disc returns to the point preset in step 6, and the CD player enters the online READY mode. (The READY key is lit.)

To adjust the setting point, press the PLAY/PAUSE key to enter the monitor PAUSE mode, and return to step 6.

9Press the ON LINE key to start playback. When the tune ends, playback stops.

z To cancel playback, press the STOP key.

Auto-registering Cue Points

In the default setting, the position where monitor playback was last started from the monitor PAUSE mode is automatically registered as the cue point. When the READY key is pressed during monitor playback, the CD-601MKII is located to the cue point and enters the online READY mode.

By using menu item No. 20 (“CUE_SET”), you can select either of the following two conditions as the condition for auto-registering the cue point.

NOR (default setting): The position where monitor playback was last started from the monitor PAUSE mode is automatically registered as the cue point.

RDY : The position where monitor playback was started from the monitor PAUSE mode, or the position where the READY key was pressed from the monitor PAUSE mode is auto-registered as the cue point.

zFor details on menu operations, see “Menu Operations” (page 17).

[NOTE]

When the Remote Control Unit RC-601MKII (sold separately) is used, the above auto-registered cue points can be registered to CUE1 to CUE10.

14 TASCAM CD-601MKII