EXTERNAL CONTROL
Control from the RC-601MKII
Functions are added to the CD player and the CD player becomes easier to user by using the Remote Control Unit
Expanded and additional functions by the
•Time chart/index search using the numeric keys
•Search using the jog/search dial
•End check function that allows you to listen to the end of tracks
•1 tune repeat, all tunes repeat, program repeat, repeat playback between A and B
•Max. 10 cue points can be set to a single disc.
•Flash start function using 10 cue points
•Cue point settings for 500 discs can be stored to memory.
•Playback between A and B using MEMO points and confirmation playback of points are possible.
•The monitor outputs of up to four
Setting operation on the CD player
Operation on the CD player can be selected between enabled and disabled when the
Set enable/disable using menu No. 17 (“RMT”).
R_L (REMOTE + LOCAL, default): Operation of the CD player is possible on both the
R (REMOTE): Operation of the CD player is possible on only the
Operation of the CD player except the OPEN/CLOSE key is disabled.
When the
Control from the RS-232C interface
The CD player can be controlled on the serial interface from a PC or other external equipment using the REMOTE (SERIAL) terminal
8 | 1 |
15 | 9 |
Pin Arrangement
Pin No. | Signal Name | IN/OUT |
|
1 | SHIELD | – | Shielded (shell ground) |
2 | RX | IN | Receive data |
3 | (Reserved) | – | Reserved |
4 | (Reserved) | – | Reserved |
5 | (Reserved) | – | Reserved |
6 | GND | – | Ground |
7 | (Reserved) | – | Reserved |
8 | (Reserved) | – | Reserved |
9 | TX | OUT | Send data |
10 | (Reserved) | – | Reserved |
11 | (Reserved) | – | Reserved |
12 | (Reserved) | – | Reserved |
13 | (Reserved) | – | Reserved |
14 | (Reserved) | – | Reserved |
15 | (Reserved) | – | Reserved |
Setting the baud rate
When the REMOTE (SERIAL) terminal is used to control the CD player, select the appropriate baud rate from the following using menu No. 23 (“RS232C”).
26 TASCAM