3 − Preparation for Use

15-16 STEREO IN jack on the top panel, select channels 13-14 as the return channels by setting the INT. EFFECT RTN switch so that it is not pushed in.

STEREO IN jack

When using channels 13-14 as the return channels, do not use the channel 13-14 input jacks on the rear panel. When using channels 15-16 as the return channels, do not use the STEREO IN jack on the top panel.

Turning the power on and putting the mixer in standby

Before turning the power on

1Prepare the mixer as follows.

Set the EQ, PAN and BAL knobs to their center posi- tions.

Turn other knobs completely to the left (minimum). Lower faders completely (minimum).

Turn switches OFF (not pushed in).

2Minimize the output levels of sound sources and the input levels of amplifying equipment connected to the mixer.

Turning on the power

1Turn the mixer power ON using the ON/STANDBY switch on the rear panel of the mixer.

The indicator on the right of the meter panel lights.

Indicator

2Turn the power of the connected input sound source equipment ON.

3Finally turn the power of the connected amplifica- tion system ON.

Putting the mixer in standby

To put the mixer in standby, reverse the procedures above. Failure to do so might cause noise that could damage the equipment.

TASCAM M-164/M-164FX/M-164UF 17