2 − Names and Functions of Parts

Top panel

**

*

*

1**USB indicator

Lights when the mixer is connected to a computer by USB.

2Input channel meters

Display the input level of each input channel (levels after signals pass through the EQ section).

3MONITOR (L, R) meters

Display the output signal level of the monitoring source (stereo, SUB or AUX 1 bus) that has been selected with the two switches at the MONITOR section.

4 indicator

Lights when the mixer power has been turned ON using the ON/STANDBY switch on the rear panel.

5+48V indicator

Lights when the phantom power has been turned ON using the PHANTOM (+48V) switch on the rear panel.

*M-164FX, M-164UF only

**M-164UF only

6TRIM knobs (channels 1–6)

Use to adjust the input levels of signals from the MIC and LINE input jacks. While observing the channel meters above, turn to the left (toward LINE) for line level sources (electronic instruments, audio equipment, etc.) or to the right (toward MIC) for microphones.

7EQ section (channels 7-8, 9-10)

These channels each have a 2-band EQ.

The EQ HI knob adjusts the high frequency range with a roll-off frequency of 12 kHz and a boost/cut range of ±15 dB.

The EQ LOW knob adjusts the low frequency range with a roll-off frequency of 100 Hz and a boost/cut range of ±15 dB.

TASCAM M-164/M-164FX/M-164UF 7