Using a record player

An analog record player can be directly connected to mixer channels 9-10.

Make the following connections and settings to use an analog record player with this mixer.

•• Connect the record player audio output to the channel 9-10 input jacks on the rear panel of the mixer.

•• Connect the record player grounding wire to the SIGNAL GND jack on the rear panel of the mixer.

Record player

•• Turn the PHONO ON switch on the top panel ON (push switch in).

4 − Using the mixer

Making final adjustments to the main output sound

The stereo bus has a 2-band EQ with HI and LOW shelving that can be used to adjust the sound of the mix overall.

The EQ HI and EQ LOW knobs can boost and cut the high and low frequency ranges by ±15 dB.

Use the EQ HI knob to boost or cut the frequency band above 12 kHz, and use the EQ LOW knob to boost or cut the frequency band below 100 Hz.

The output signals of analog record players are different from ordinary line output signals. If the connections and settings described above are not made, the playback sound will not be correct.

TASCAM M-164/M-164FX/M-164UF 25