6 − Recording

Sync Record operation

When you put the SS-R1 in record-ready condition with the Sync Record function on, recording will automatically start or stop according to the level of the input source.

• When a signal higher than the sync level is input,
recording will begin automatically.

However, recording will not begin even if input is

detected unless there has been at least one second in

•To defeat Sync Record, press the remote’s SYNC REC key.

•When the sync level is too high:

If the sync level setting is too high, you may have problems such as failing to capture the beginning of a song that begins with a low volume.

which the signal was below the sync level after enter-

ing the record-ready state.

Level

Recording starts

This part of the track may not be recorded

Level

Start of recording

SYNC LEVEL

SYNC LEVEL

Time

NOTE

The above explanation is for the case when the DELAY setting is “0” (the default setting). By changing the DELAY setting, you can change the “record start” point.

•While recording, if the input signal stays below the sync level for the duration specified by STOP TIME (default: 5 seconds), the SS-R1 will auto- matically switch to the record-ready condition.

Level

REC ready

STOP TIME

SYNC LEVEL

Time

NOTE

If you set the STOP TIME to INF, the record-pause state will not be entered even though the input signal falls below the sync level.

Time

•If the sync level is too low:

Sync recording will not begin if the source you’ re recording has a high noise level, so that the sync level is exceeded immediately when you enter the record-ready state.

Level

Start of track is not registered

SYNC LEVEL Noise is higher than threshold

Time

40 TASCAM SS-R1