25
Models 750, 751, 754, 774, 791, 794 Operating Procedures
Step 7
Snap the design cap(s) over the end of the door
spout(s).
Figure 16
Step 8
Install the front drip tray and the splash shield under
the door spout(s).
Figure 17
Step 9
Slidethe rear drip pan(s) into the hole in the side panel.
Figure 18
Models791 & 794: Slidethe rear drip pan into t hehole
in the front panel.
Step 10
Slidet wo o-r ings on one end of the air tube. Slide two
o-rings on t he other end of the air tube.
Figure 19
Slidet he small o- ring into the groove of the air orifice.
Do not lubricate the o- ring.
Figure 20
Note: Makesure t he hole in the air orifice is clean and
is not clogged. If the hole in the air orifice should
become clogged, use soap and hot water to clear the
hole. Do not enlargethe hole in the air orifice.