30 Models 750, 751, 754, 774, 791, 794Operating Procedures
080324
Step 6
When a steady stream of cleaning solution is flowing
from the prime plug opening in the bottom of t he
freezer door,lower the draw handle. Draw off all of the
solution.
Step 7
Once the cleaner stops flowing from the door spout,
raise the draw handle and press the WASH key
cancelling the WASH mode.
Repeat steps1 through 7 f or the other side of the
freezer on Models 754, 774, 791, and 794.
Disassembly
MAKE SURE POWER SWITCH IS IN THE
“OFF” POSITION! Failure to follow this instruction
may result in severe personal injury from hazardous
moving parts.
Step 1
Remove the handscrews, freezer door(s), beater(s),
scraper blades, and drive shaft(s) from the freez ing
cylinder(s). Take these parts to the sink for cleaning.
Step 2
Remove the front drip tray and the splash shield.
Brush Cleaning
Step 1
Preparea s ink with an approved cleaning solution (ex-
amples: Kay- 5ror Stera- S heenr). USE WARM WA-
TER AND FOLLOW THE MANUFACTURER’S SPE-
CIFICATIONS. If another approved cleaner is used,
dilute it according to the label instructions. ( IMPORT-
ANT: Follow the label directions. Too STRONG of a
solution can cause parts damage, while too MILD of a
solution will not provide adequate cleaning.) Make
sureall brushes providedwith the f reezer are available
for brush cleaning.
Step 2
Remove the seal(s) from the drive shaft(s).
Step 3
From the freezer door(s) remove:
Sgasket(s)
Sfront bearing(s)
Spivot pin(s)
Sadjustable draw handle(s)
Sdesign cap(s)
Sdraw valve(s)
Sprime plug(s)
Sall o- rings
Note: Toremove o- rings, use a single service towel
to grasp the o- ring. Apply pressure in an upward
direction until the o- ring pops out of its groove. With
the other hand, push the top of t he o- ring forward and
itwill roll out of the groove and can be easily rem oved.
Ifther e is more than one o- ring to be removed,always
remove the rear o- ring first. This will allow the o- ring
to slide over the forward rings without falling into the
open grooves.
Step 4
Remove the o- rings from the air tube(s) and air
orifice(s).
Step 5
Return to the freezer with a small amount of cleaning
solution. Brush clean the rear shell bearing(s) at t he
back of the freezing cylinder(s) with the black brist le
brush.
Figure 34
Step 6
Remove the rear drip pan(s) and take to the sink for
cleaning.
Note: Ifthe drip pan is filled with an excess iveamount
of mix, refer to the Troubleshooting Guide.
Step 7
Thoroughly brush clean all disassembled parts in the
cleaningsolution making s ure all lubricant and mix film
is removed. Take particular care to brush clean the
draw valve core(s) in the freezer door. Place all the
cleaned parts on a clean, dry surface to air dry
overnight.
Step 8
Wipe clean all exterior surfaces of the freezer.