1
Models 750, 751, 754, 774, 791, 794 Tot he Installer
131206
Section 1 To the Installer
The following information has been included in the
manual as safety and regulatory guidelines. For
complete installation instructions, please see the
Installation Checklist.

Installer Safety

Inall areas ofthe wor ld, equipment should be
installed in accordance with existing local codes.
Please contact your local authorities if you have any
questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and
service of Taylor equipment.
SOnly authorized Taylor service personnel
should perform installation and repairs on the
equipment.
SAuthorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
SAuthorized service personnel must ensure
that the proper PPE is available and worn
whenrequir ed during installation and service.
SAuthorizedserv ice personnel must remove all
metal jewelry, rings, and watches before
working on electrical equipment.
The main power supply(ies) to the freezer
must be disconnected prior to performing any repairs.
Failure to follow this instruction may result in personal
injury or death from electrical shock or hazardous
moving parts as well as poor performance or damage
to the equipment.
Note:Allrepairsmustbeperformed byan
authorized Taylor Service Technician.
This unit has many sharp edges that can
cause severe injuries.

Site Preparation

Review the area the unit is to be installed in before
uncrating the unit making sure that all possible
hazards the user or equipment may come into have
been addressed.

Air Cooled Units

DO NOT obstruct air intake and discharge openings:
Counter Model:6” (152 mm ) minimum air spaceon
both sides and 0” on the rear.
ConsoleModels: 3” (76 mm) minimum air space on
all sides.
This will allow for adequate air flow across the
condenser(s).F ailure to allow adequate clearance can
reduce the refrigeration capacity of the freezer and
possiblycause permanent damageto the compressor.
ForIndoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of
70_-75_F(21_-24_C). The freezer has successfully
performed in high ambient temperatures of
104_(40_C) at reduced capacities.
This unit must NOT be installed in an area
where a water jet or hose can be used. NEVER use a
water jet or hose to rinse or clean the unit. Failure to
follow this instruction may result in electrocution.
This unit must be installed on a level surface
toavoid t he hazard of tipping. Extreme care should be
takenin mov ing this equipment for any reason. Two or
more persons are required to safely move this unit.
Failure to comply may result in personal injury or
equipment damage.
Uncratet heunit and inspect i t fordamage. Repor tany
damage to your TaylorDis tributor.
This piece of equipment is made in the USA and has
USA sizes of hardware. All metric conversions are
approximate and vary in size.