17
Model 811, 813, 819, 821 Series Operating Procedures
130206
Section 6 Operating Procedures
The three platen Model L811 has been selected to
illustrate the step-by-step procedures. For grills
equipped with less than three platens, perform the
following steps as appropriate for your grill platen
configuration.

Daily Opening Procedures

Before operating the grill, the release sheets must
be installed on the upper platens. The release
sheets are reversed and rotated on a daily basis
(black side vs. gray side.)
Perform the following steps for installing release
sheets:
CAUTION: Make sure the grill is COOL
before attempting to install or remove release
sheets.
Step 1
Slide the release sheet retainer through the hemmed
end of the release sheet.
Figure 11
Step 2
Hook the release sheet retainer on the release sheet
shoulder screws at the top of the upper platen.
Figure 12
Step 3
Hold the non-hemmed end of the release sheet.
Gently pull the sheet tight, wrapping it around the
platen in a side-to-side manner.
Figure 13
Note: Check the alignment of the release sheet and
make sure it fits smoothly over the upper platen.