4Model 811, 813, 819, 821 SeriesSafety
130304
Section 3 Safety
We, at Taylor Company, are concerned about the
safety of the operator when he or she comes in
contact with the grill and its parts. T aylor has gone
to extreme efforts to design and manuf acture built-in
safety features to protect bot h you and the service
technician. As an example, warning labels have
been attached to the grill to further point out safety
precautions to the operator.
IMPORTANT - Failure to adhere to the
following safety p recautions may result in
severe personal injury or deat h. Failure to
comply with these warni ngs may damage the
machine and its components.Component
damage will result in partreplacement expense
and service repair expense.

To Operate Safely:

DO NOT operate the grill without reading
this operator's manual. This manual should be kept
in a safe place for future reference.
This appliance is to be used only by trained
personnel. It is not intended for use by children or
people with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge,
unless given supervision or instruction concerning
the use of the appliance by a person responsible for
their safety. Children should be supervised to ensur e
that they do not play with the appliance.
Failure to follow the instructions below may
result in severe injury or death from electroc ution:
SDO NOT operate the grill unless it is
properly grounded.
SDO NOT operate the grill with larger fuses
than specified on data label.
SDO NOT operate the grill unless all service
panels and access doors are attached with
screws.
SAll repairs must be performed by an
authorized Taylor service technician.
SThe main power supplies to the grill must be
disconnected prior to performing any
repairs.
SFor Cord Connected Units: Only Taylor
authorized service technicians or licensed
electricians may install a plug or
replacement cord on these units.
SStationary appliances which are not
equipped with a power cord and a plug or
other device to disconnect the appliance
from the power source must have an all-pole
disconnecting device with a contact gap of
at least 3 mm installed in the external
installation.
SAppliances that are permanently connected
to fixed wiring and for which leakage
currents may exceed 10 mA, particularly
when disconnected or not used for long
periods, or during initial installation, shall
have protective devices such as a GFI, to
protect against the leakage of current,
installed by the authorized personnel to the
local codes.
SSupply cords used with this unit shall be
oil-resistant, sheathed flexible cable not
lighter than ordinary polychloroprene or
other equivalent synthetic elastomer-
sheathed cord, (Code designation 60245
IEC 57), installed with the proper cord
anchorage to relieve conductors from strain,
including twisting, at the terminals and
protect the insulation of the conductors from
abrasion.
If the supply cord is damaged, it must be
replaced by the manufacturer, its serv ice
agent, or similarly qualified person, in order
to avoid a hazard.