1
Model 811, 813, 819, 821 Series To the Installer
Section 1 To the Installer
The following are general installation instructions.
For complete installation details, please see the
checkout card.

Installer Safety

In all areas of the world, equipment should
be installed in accordance with existing local codes.
Please contact your local authorities if you hav e any
questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installat ion and
service of Taylor equipment.
SOnly Taylor authorized service personnel
should perform installation and repairs on
the equipment.
SAuthorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
SAuthorized service personnel must ensure
that the proper PPE is available and worn
when required during installation and
service.
SAuthorized service personnel must remove
all metal jewelry, rings, and watches before
working on electrical equipment.
The main power supply(s) to the equipment
must be disconnected prior to performing any
repairs. Failure to follow this instruct ion may result in
personal injury or death from electrical shock or
hazardous moving parts as well as poor
performance or damage to the equipment.
Note:Allrepairsmustbeperformedbyan
authorized Taylor Servi ce Technician.
This unit has many sharp edges that can
cause severe injuries.

Site Preparation

Review the area where the unit will be installed
before uncrating the unit. Make sure all possible
hazards to the user or equipment have been
addressed.

Electrical Connections

The grill is supplied with one power cord. Check the
data plate on the grill for voltage, cycle, phase and
electrical specifications.
For proper power connections, refer to the wiring
diagram provided inside the left side panel, attached
to the gas manifold assembly. The power connect ion
is located behind the access line cover on the front
of the grill.
In the United States, this equipment is int ended to
be installed in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70-1987. The
purpose of the NEC code is the practical
safeguarding of persons and property from hazards
arising from the use of electricity. This code contains
provisions considered necessary for safety.
Compliance therewith and proper maintenance will
result in an installation essentially free from hazard!
In all other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local authorities.
The Proper Wire Size and Branch Circuit
Overcurrent Device shall be selected according t o
the data label information and in accordance with
CEC Part I 2006, Section 14-100(e)(i).
FOLLOW YOUR LOCAL ELECTRICAL CODES!