Taylor 811, 819, 821

32 Model 811, 813, 819, 821 SeriesOperating Procedures

130201

Step 13

Using an approved high temperature grill cleaner,

pour approximately 3 oz. (90 ml) onto each 12”

(305 mm) cook zone.

Figure 54

Step 14

Firmly attach the non-abrasive pad to the grill

cleaning pad holder.

IMPORTANT! Use the grill cleaning pad

and holder identified on page 15 ONLY. Using

any other pad and holder will damage the release

sheets.

Step 15

Dip the pad into the grill cleaner.

IMPORTANT: DO NOT SCRUB while applying

grill cleaner in the following steps:

Step 16

Apply grill cleaner to the front side of the upper

platens.

Figure 55

Step 17

Apply grill cleaner to the bottom of the platen

handles.

Figure 56

DO NOT use metal scrapers, abrasive

pads, screens, or wire brushes. Damage to

components may result.

Step 18

Apply grill cleaner to the platen surfaces.

Figure 57

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Electrical Connections Installation Installation of Cable Kit Ventilation and Clearance Grease Disposal Container Section 2 To the Operator Section 3 Safety To Operate Safely: S S S S S S S S S 7 Model 811, 813, 819, 821 Series Operator Parts Identificatio n Section 4 Operator Parts Identification C811 Exploded View Figure 1 8Model 811, 813, 819, 821 SeriesOperator Parts Identifi cation L811 Exploded View Figure 2 9 Model 811, 813, 819, 821 Series Operator Parts Identificatio n C813 Exploded View Figure 3 10 Model 811, 813, 819, 821 SeriesOperator Parts Identifi cation L813 Exploded View Figure 4 11 Model 811, 813, 819, 821 Series Operator Parts Identificatio n C819 Exploded View Figure 5 12 Model 811, 813, 819, 821 SeriesOperator Parts Identifi cation L819 Exploded View Figure 6 13 Model 811, 813, 819, 821 Series Operator Parts Identificatio n C821 Exploded View Figure 7 14 Model 811, 813, 819, 821 SeriesOperator Parts Identifi cation L821 Exploded View Figure 8 15 Model 811, 813, 819, 821 Series Operator Parts Identificatio n Accessories Figure 9 Section 5 Important: To the Operator Section 6 Operating Procedures Daily Opening Procedures Replace the release sheet when: S Care of Release Sheets S StartUpoftheGrill Page Programming Menu Items UNITS Key ADJUST VOLUME Key MENU EDIT Key S S S SERVICE CONTACT INFORMATION Key VIEW HELP Key LoadingStoreMenuItemsToUSB LoadingMenuItemsFromUSB Page Page Operating Procedures Cooking Product Standby Procedures Menu Parameters Cleaning After Each Run of Product Daily Cleaning Procedures Page Page Page Page Page S S S S 24 Hour Stores Only: Non-24 Hour Stores Only: Section 7 Troubleshooting Guide Page Page Page GAS ZONES ONLY Section 8 Warranty Explanation Section 9 Parts List