Taylor 811, 819, 821 Replace the release sheet when:

18 Model 811, 813, 819, 821 SeriesOperating Procedures
130205
Step 4
Place the release sheet clips over the release sheet.
Press them into place over the release sheet bar at
the top of the platen.
Figure 14
Step 5
Check the tightness of the release sheet against the
upper platen.
Figure 15
Note: Installing the release sheets too tightly may
cause premature failure of the sheet.
Step 6
Repeat steps 1 through 5 for the remaining upper
platen(s).
Note: Temperature checks should only be
conducted with the release sheets removed.
Replace the release sheet when:
SCleaning procedures fail to remove all
buildup and product sticks to the release
sheet.
SA tear appears in the cooking area of the
release sheet, causing product to stick to the
release sheet.
Figure 16
CAUTION: The upper platen surface and
release sheet are very hot. To prevent burn
injuries, wear heat-resistant gloves when
replacing the release sheets.
Note: It is not necessary to change the release
sheet if small pin holes develop on the sheet.