19
Model 811, 813, 819, 821 Series Operating Procedures
110602
Care of Release SheetsDO NOT:
SDO NOT fold or crease.
Figure 17
SDO NOT touch with sharp objects, grill
scrapers, or abrasive pads.
SDO NOT place under other equipment or
objects.
SDO NOT hot-hose or soak in water.
DO:
SDO clean with a squeegee after each run of
product.
SDO wipe with a clean, sanitizer-soaked grill
cloth a minimum of 4 times per hour and
more often during peak periods.
SDO clean daily on both sides, using an
approved high temperature grill cleaner and
the grill cleaning pad and holder identified
on page 15.
IMPORTANT! Clean the release
sheets using the grill cleaning pad and
holder identified on page 15 ONLY. Using
any other pad and holder will damage the
release sheets.
Figure 18
Note: Contact your local Taylor Distributor to
purchase the correct grill cleaning pad and holder.
(See page 15.)
SDO rinse to remove cleaner and allow to dry
on a flat surface.
SDO rotate the release sheet daily and
re-install on opposite side than previously
used (black side vs. brown side).
StartUpoftheGrillIMPORTANT! The lower grill surface and the
upper platen MUST BE CLEAN before starting
these procedures.
Step 1
Place the power switch in the ON position.
Figure 19