4Models 8752 & 8756 with Horizon®PumpTothe Op erator
Section 2 To the Operator
The freezer you have purchased has been carefully
engineeredand manufact ured to give you dependable
operation. The Taylor Models 8752 and 8756 are
highly sophisticated pieces of equipment, and when
properly operated and cared for, will produce a
consistent quality product. Like all mechanical
products, they will require cleaning and maintenance.
Aminimum amount of c are and attention is necessary
if the operating procedures outlined in this manual are
followed closely.
This Operator’s Manual should be read before
operating or performing any maintenance on your
equipment.
Your freezer will NOT eventually compensate and
correct for any errors during the set--up or filling
operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is strongly
recommended that all personnel responsible for the
equipment’s operation study these procedures
together in order to be properly trained and to make
sure that no misunderstandings exist.
In the event you should require technical assistance,
pleasecontact yourlocal authoriz ed TaylorDistributor.
Note: Warrantyis valid only if theparts are author ized
Taylor parts, purchased from an authorized Taylor
Distributor, and the required service work is provided
by an authorized Taylor service technician. Taylor
reserves the right to deny warranty claims on
equipment or parts if non--approved parts or
refrigerant were installed in the machine, system
modifications were performed beyond factory
recommendations, or it is determined that the failure
was caused by neglect or abuse.
Note: Constant research resu lts in steady
improvements; therefore, information in this
manualis subject to change without notice.
If the crossed out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliantwith t he EU Directive as well as other similar
legislation in effect after August 13, 2005. Therefore,
it must be collected separately after its use is
completed, and cannot be disposed as unsorted
municipal waste.
Theuser isrespons ible for returning the product t o the
appropriatecollection f acility,as spec ified by your local
code.
For additional information regarding applicable local
laws, please contact the municipal facility and/or local
distributor.

Compressor Warranty Disclaimer

The refrigeration compressor(s) on this machine ar e
warranted for the term indicated on the warranty card
accompanying this machine. However, due to the
Montreal Protocol and the U.S. Clean Air Act
Amendments of 1990, many new refrigerants are
being tested and developed, thus seeking their way
into the service industry. Some of these new
refrigerants are being advertised as drop--in
replacements for numerous applications. It should be
noted that, in the event of ordinary service to this
machine’srefrigeration system, only the refrigerant
specifiedon the affixeddata label should be used.
Theunauthorized use of alternater efrigerants will void
your compressor warranty. It will be the owner’s
responsibilityto mak e this fact known to any technician
he employs.
Itshould also be not ed that Taylordoes not warrant the
refrigerant used in its equipment. For example, if the
refrigerant is lost during the course of ordinary service
to this machine, Taylor has no obligation to either
supply or provide its replacement either at billable or
unbillable terms. Taylor does have the obligation to
recommend a suitable replacement if the original
refrigerantis banned,obsoleted, or no longer available
during the five year warranty of the compressor.
The Taylor Company will continue to monitor the
industry and test new alternates as they are being
developed.Should a new alternate prove, through our
testing, that it would be accepted as a drop--in
replacement, then the above disclaimer would
become null and void. Tofind out t he current status of
an alternate refrigerant as it relates to your
compressor warranty, call the local Taylor Distributor
or the Taylor Factory. Be prepared to provide the
Model/Serial Number of the unit in question.