Connections

After all connections are complete, connect the power cord’s plug to the AC wall socket.

Read the instructions of each device that you intend to use with this unit.

Be sure to connect each plug securely. To avoid hum and noise, do not bundle the connection cords.

AD-800 (back side)

cables RCA

 

 

 

 

Amplifier

Wall

 

 

 

 

 

 

 

 

socket

 

 

 

 

 

 

 

 

 

 

LINE LINE

OUT IN

Tuner, etc.

Speakers

Example

16

ALINE IN/OUT jacks

These jacks transmit an analog 2-channel audio signal. Connect the components using the included RCA pin cables.

Be sure to connect:

 

White plug F White jack

(L: left channel)

Red plug F Red jack

(R: right channel)

BAC Power Cord

After all other connections are complete, connect the plug to an AC wall outlet.

Be sure to connect the power cord to an AC outlet that supplies the correct voltage.

Hold the power plug when plugging it into an outlet or unplugging it. Never pull or yank on the power cord.

Voltage Selection

(General export/North America models only)

Be sure to remove the power cord from the AC outlet before changing the position of the voltage selector switch.

1.Locate the VOLTAGE SELECTOR switch on the rear panel.

2.Using a flat-bladed screwdriver, set it to the appropriate position (230 V or 120 V) for the power supply used in your area.

IN NORTH AMERICA USE ONLY ON 120 V SUPPLY.

Notes on turning on or off the power

When an amplifier is connected to the AD-800, turn on or off the power of the AD-800 and the amplifier in the following sequence.

When turning on the power

1.AD-800

2.Amplifier

When turning off the power

1.Amplifier

2.AD-800