Timer-Controlled Playback and Recording (2)

NOTE

If you have previously used the cassette, and the tape is stopped part of the way through “side B” of the cassette, timer recording will then start part of the way through “side A”. Always bear this in mind, so that you do not accidentally erase any important recordings. You should take special note of this when recording more than once on the same cassette using the timer recording function.

4Set the CD-TAPE-USB switch to TAPE.

This unit cannot record to CDs and USB storage devices with the timer recording.

5Set the OFF-PLAY-REC switch to the REC position.

“TIMER” and appear on the AD-800’s display.

6Tune in the station that you want to record (when recording from radio).

7Adjust the recording level.

Failure to do so could cause the recorded sound to be distorted or noisy.

Use the REC LEVEL knob to adjust the recording level so that the loudest sound does not continually exceed the “0” indicator on the peak level meter.

8Set the audio timer to your desired start (power on) and stop (power off) times.

When this setting is completed, the power to all components will be switched off.

At this time, do not press the AD-800 POWER button. Leave the button pushed in (the on position). If the POWER button is in the off position, timer recording will not function.

When the preset start time is reached, power will be supplied and recording will start automatically.

When you do not want to use the timer, be sure to set the OFF- PLAY-REC switch to the OFF position to prevent accidentally recording over an important cassette tape.

36