How to open/close the turntable cover

To Open:

1Lift the turntable cover all the way up until it stops.

2.Lower the cover slowly until the latch engages.

3.The cover will now stay open. If the latch does not engage, repeat these steps again.

To Close:

1.Lift the cover all the way up until it stops.

2.The latch should disengage and you may now slowly lower the cover.

3.Make sure you grasp the cover by the edges to avoid pinching your fingers as it closes.

Assembling the Turntable

Caution:

<There is a drive belt hooked to the turntable platter's drive rim. Be careful not to damage the drive belt when assembling the turntable.

<When turning on the power to the unit, the tone arm may move if the cum was subjected to shock during transportation and has been displaced.

We suggest you to assemble the turntable leaving the vinyl tie intact that holds the tone arm.

When you use the GF-650 for the first time after you have assembled the turntable (or after the GF-650 has been transported), turn on the power to the unit and leave this alone for more than 30 seconds. Thereafter remove the vinyl tie.

1.Hook your fingers into the round holes of the turntable platter and gently lift.

2.Carefully place the turntable platter on the center spindle, making certain the platter is fully seated on the spindle.

Round hole

Square opening

 

Base plate

3.Turn the turntable platter by hand until the motor pulley is visible through a square opening in the turntable platter.

4.Insert your finger into the square opening and carefully pull the end of the red tape ribbon so that the drive belt hooks to the motor pulley.

Red tape ribbon

Pulley

Drive belt

Turntable platter

8