5.Remove the red tape ribbon.

6.Slowly turn the turntable platter 5 or 6 times by hand so that the drive belt is correctly seated into the pulley's groove.

7.Place the record mat on top of the turntable platter.

8.Completely loosen the shipping screws by turning them clockwise with a coin or screwdriver.

Cushioning material

Shipping screw

When needed for transportation

1.Disassemble and pack the turntable in reverse order of assembly.

2.Insert the two white cushioning materials into beneath the base plate.

3.Rotate the two shipping screws counterclockwise until they block.

4.Put the stylus guard back on.

5.Hold the tone arm with the vinyl tie.

If the drive belt is out of place

1.Lift and remove the turntable platter, and place it bottom side up.

2.Place the drive belt along the outside wall of the turntable platter’s drive rim.

3.Reassemble the turntable by following steps 1-7 of page 8 explained under the heading “Assembling the Turntable”. But, in step 4, gently hold the drive belt itself (instead of the red tape ribbon) and hook it to the motor pulley, and skip step 5.

ENGLISH

Base plate

Shipping screw

cushioning material

9.Remove the two white cushioning materials from beneath the base plate.

We suggest that you save the cushioning materials for possible future moving or shipping.

9