Basic Operation (1)
This chapter describes the basic operation which is available in every mode.
When you use the unit for the first time, set the clock and the setting of the unit. (see previous page for “Setting the Clock” and page 33 for “Settings”).
1Press the STANDBY/ON button to turn the unit on.
<The unit turns on with the source that was last selected.
<You can also use the FUNCTION button (or the FM, DVD, USB or AUX button on the remote control unit) to turn the unit on.
2Press the FUNCTION button to select a source.
Each time the FUNCTION button is pressed, the source changes as follows:
FM Radio
DISC Source
USB Source
AUX1 Source
AUX2 Source
The selected source is shown on the front panel display.
<To listen to an external source connected to the AUX IN jack, select AUX1 or AUX2.
<You can also select AUX1 or AUX2 by pressing the AUX button on the remote control unit once or twice.
3Play the source, and adjust the volume using the VOLUME knob.
The volume is adjustable from MIN to MAX. You can hold down the VOLUME – or + buttons on the remote control unit to reduce or bring up the volume continuously.
<Press the STANDBY/ON button to put the unit in the standby mode when it is not being used.
ECO Power Standby mode
When you press the STANDBY/ON button to put the unit in the standby mode, “ECO POWER” is shown on the display first, then the clock is shown in a few seconds before the unit turns off the display to save the power consumption.
<In ECO Power Standby mode, the illumination of the STANDBY/ ON button lights orange.
To show the clock on the display during ECO Power Standby mode, press the CLOCK button. The illumination of STANDBY/ON button turns off.
<If no operation is done for a few minutes, the unit switches to ECO Power Standby mode again.
20