Before Use

What’s in the box

Confirm the supplied standard accessories.

Remote control unit (RC-1271) x 1

Batteries (AAA, R03, UM-4) for remote control unit x 2

Speaker x 2/Subwoofer x 1

RCA video cable x 1

FM antenna x 1

Owner’s manual (this document) x 1

<Keep this manual in a safe place for future reference.

Warranty card x 1

Beware of condensation

When the unit is moved from a cold to a warm place, or used after a sudden temperature change, there is a danger of condensation; vapor in the air could condense on the internal mechanism, making correct operation impossible. To prevent this, or if this occurs, leave the unit turned on for one or two hours. Then the unit will stabilize at the temperature of its surroundings.

Placement of the unit

<Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture.

<As the unit may become warm during operation, always leave sufficient space around the unit for ventilation.

Make sure there is at least 8” (20 cm) of space above and at least 2” (5 cm) of space on each side of the unit. Do not place anything on top of the unit.

<Do not place the unit on an amplifier or receiver or any other device that generates heat.

<When the unit is turned on, switching on the TV may cause lines to appear on the TV screen, depending on the condition of the electric waves of the TV broadcast. This is not malfunction in the unit or the TV. If you see such lines, keep this unit well away from the TV set.

CAUTION

<Do not move the unit during disc playback.

During playback, the disc rotates at high speed. Do not lift or move the unit during playback. Doing so may damage the disc or the unit.

<The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician.

<Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or service company.

<When removing the power plug from the wall outlet, always pull directly on the plug, never yank on the cord.

<To keep the laser pickup clean, do not touch it and always close the disc tray.

<Always remove the disc before relocating or moving this unit. Moving the unit with a disc inside it could cause malfunction.

Maintenance

If the surface of the unit gets dirty, wipe it with a soft cloth or use diluted mild liquid soap. Allow the surface of the unit to dry completely before using.

For safety, disconnect the power cord from the socket before cleaning.

<Never spray liquid directly on this unit.

<Do not use thinner or alcohol as they could damage the surface of the unit.

5