Settings (VIDEO SETUP)

VIDEO OUTPUT

This setting is for selecting the output terminal of the video. You can select “S-VIDEO” (S-video output) or “Y Cb/Pb Cr/Pr” (Component video output).

S-VIDEO

Select this if you have connected the unit to your TV using S-Video jack.

Y Cb/Pb Cr/Pr

Select this if you have connected the unit to your TV using Component video jacks.

<When your TV is connected to the HDMI terminal, no signal is output from the component video output jacks.

TV MODE

This setting allows the selection of interlaced (INTERLACE) or progressive-scan (PROGRESSIVE) video from the component video outputs.

Progressive-scan video provides a better, clearer picture. However, it is not supported by every TV or monitor, and you should ensure that this is supported fully before turning on this option.

<When your TV is not compatible with progressive scanning, never select “PROGRESSIVE”. Otherwise, a picture is distorted or no picture will be shown on the monitor.

In case you select “PROGRESSIVE” by mistake, disconnect the connection of the MC-DV600 and the TV, and then connect in again. And change the setting to “INTERLACE” in the VIDEO SETUP menu.

Consumers should note that not all high definition TV sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of 480 (525) or 576 (625) progressive scan picture problems, it is recommended that the user switch the connection to the ‘standard definition’ output. If there are questions regarding our TV set compatibility with this model 480p (525p) and 576p (625p) DVD player, please contact our customer service center.

COLOR SETTING

You can adjust some parameters of video picture.

1Highlight “COLOR SETTING” and press the right (t) button.

2Use the left and right (g/t) buttons to select the parameter.

SHARPNESS

This adjusts the sharpness of the picture shown on the monitor. Select HIGH, MEDIUM or LOW using the Cursor buttons, then press the ENTER button.

BRIGHTNESS

This adjusts the brightness of the picture.

Use the left and right buttons to change the value from –20 to 20, then press the ENTER button.

CONTRAST

This adjusts the picture contrast.

Use the left and right buttons to change the value from –16 to 16, then press the ENTER button.

GAMMA

This adjusts the gamma value of the picture.

Select HIGH, MEDIUM, LOW or NONE using the Cursor buttons, then press the ENTER button.

HUE

This adjusts the green/red balance of the picture (only for progressive-scan output).

Use the left and right buttons to change the value from –9 to 9, then press the ENTER button.

SATURATION

This adjusts the saturation level.

Use the left and right buttons to change the value from –9 to 9, then press the ENTER button.

LUMA DELAY

This adjusts the luma delay.

Select 0 T or 1 T using the Cursor buttons, then press the ENTER button.

3Press the left (g) button to return to the VIDEO SETUP

Page.

36