Settings (AUDIO SETUP)

DIGITAL AUDIO SETUP (DIGITAL OUTPUT)

You can select the audio signal output suitable for the connected device when playing the digital source.

OFF

Select this when you do not use the DIGITAL OUT or HDMI out terminal.

No signal is output from these terminals.

ALL

Select this when the unit is connected to an audio component equipped with a built-in digital audio decoder via the DIGITAL OUT or the HDMI out terminal.

PCM only (Default)

Select this when the unit is connected to an audio component such as amplifier/receiver, CD recorder or MD deck via the DIGITAL OUT or the HDMI out terminal.

DOLBY DIGITAL SETUP (DUAL MONO)

You can select the channel output for the DVD discs recorded in Dolby digital.

STEREO

Left channel is output from the left speaker, and right channel is output from the right speaker.

L-MONO

Left channel is output from the front left and right speakers.

R-MONO

Right channel is output from the front left and right speakers.

3D PROCESSING (Reverb mode)

This setting provides following sound effects by using just two speakers:

OFF

CONCERT

LIVING ROOM

HALL

BATHROOM

CAVE

ARENA

CHURCH

AUDIO SYNC

This setting can cause delays in the sound signal in 10 ms increments ranging from 0 ms to 200 ms (only for digital signals recorded on a disc or stored in an USB device; unavailable for analog signals coming from AUX 1 or 2).

Depending on the TV, it may take approximately 100 ms (0.1 sec.) for an image to appear after video signals are input, causing the image to appear after the sound coming from the MC-DV600 is heard.

If this happens or audio and video synchronization creates a less than optimal viewing experience, adjust the delay with the left (decrease) or right (increase) Cursor (g/t) buttons.

35