Technicolor - Thomson CDP-CX57 service manual Aging procedure, Error Display, Error code

*3 Aging cycle count function:

Functions which displays the number of agings carried out on

the Fluorescent indicator tube					in numbers. One aging cycle
consists of six discs.						Aging carried
						(Hexadecimal)
	1 DISCS		CD1				1	SEC
		DISC			MIN
			TRACK
		51		1	0.02
Disc number			Track number

Aging procedure:

Some operating method will be changed depending on if the fol- lowing jig for the aging mode exists or not.

• Jig
	Parts. No	Description
	J-2501-123-A	Remote commander (For aging mode)

Error Display

1 DISCS				1
			CD1
		DISC
	40			1Err*01
Disc		number		Error	code

Without remote commander for aging mode:

1.Turn ON the power of the unit. Open the front cover.

2.Press the [PLAYÊMODE], á , and - buttons in order.

3.When the disc set mode is set, the á and P LEDs blink.

The following procedure is the same as in the case “With remote commander for aging mode”.

With remote commander for aging mode:

1.Turn ON the power of the unit. Open the front cover.

2.Press the [AGINGÊSTART] button of the remote commander for aging mode.

3.When the disc set mode is set, the á and P LEDs blink.

4.Rotate the JOG dial. The slits (No. 10, 20, 30, 40, 51) for setting the discs will come forward. Insert the discs into these slits. Do not set the discs in other slits.

5.Set the use/disuse of the self protection function in errors. Press the [REPEAT] button. When REPEAT is displayed on the fluo- rescent indicator tube, the self protection function during the error will become “Use”.

If the REPEAT display is OFF, it means that the function is not used. (Normally set to “Use” when performing aging.)

6.Press the á button.

7.The á LED blinks, the aging mode is set, and aging is started.

8.The aging cycle lasts 3 minutes. When problems occur during aging, the error number will be displayed on the fluorescent in- dicator tube, and the P LED will light up.

(Refer to the following table for the details of the errors.)

9.Aging will be repeated as long as no errors occur.

10.After each aging cycle, the number displayed on the Fluores- cent indicator tube will increase.

11.To end aging, press the I/u button

Error code

Code number		Name	Contents
Err 01	DISC sensor check 1		No disc in the specified slit
Err 02	DISC sensor check 2		Disc in other slits
Err 03			No function
Err 04	Table operation check 2		No table sensor input
Err 05	Loading operation check 1		Load in timeover
Err 06	Loading operation check 2		Load out timeover
Err *1	BU related check 1		Access timeover
Err *2	BU related check 2		High speed search NG
Err *3	BU related check 3		Q data read error
Err *4	BU related check 4		BU operation (From focus search to until signal can be read) timeover
Err *5	BU related check 5		GFS monitor error
Err *6	BU related check 6		Focus cannot be imposed by focus search

The * numbers mean the following according to the state of the unit during aging 2 : From checking to end of TOC read

3 : From end of TOC read to end of last track playback

4 : From end of last track playback to end of first track playback

– 13 –