DTH7500_en 4/07/03 16:55 Page 10
Connections and initial set up
Satellite or cable receiver
Your DMR is intended to control a satellite or cable receiver. In this case, the device must be connected to the AV2 and IR SAT/CABL connections of the DMR. Connect cables (5) (not supplied) and cable (6) the
Note: In grey: connections already carried out (connections from page 4),
In black: new connections.
Satellite receiver 
5
6
DMR |
TV set |
G-LINK CABLE - Adjusting your DMR’s IR (infrared) controller cell
You need to find the correct positioning of the IR controller cell in relation to the front of the satellite or cable receiver so that your DMR can transmit the commands as you would do with the satellite receiver’s remote control.The IR (infrared) controller cell must face the receiver cell of the satellite receiver.You can locate the receiver cell of the satellite receiver by bringing its remote control as close as possible to the front of the device and trying to change channels. Move the remote control one centimetre and try again.When the channel of the satellite receiver changes, locate the position on the front of the unit.Then install the IR controller cell as shown on the diagram below, facing the cell of the satellite receiver (1 or 2 cm away). If need be, use the adhesive supplied to stick the cell in place.
Satellite or cable receiver
IR controller cell
10
