Panasonic VDR-M70GC 154, During recording, Adjust the dioptre control, Then set it to Again

English

During recording

Symptom		Cause and Correction			Reference
					page
Recording starts but	Is disc scratched or does dirt or fingerprint adhere to it?				70
stops immediately.	Clean the disc. If there is still no improvement, replace the disc.
	If you turn this DVD Video Camera on for many hours in a high
	temperature location, this DVD Video Camera may automatically
	stop recording for the protection of the lens in the laser pickup				
	assembly. In this case, follow the messages on the display of this
	camera. To start the recording again, turn this
	camera off and leave it for a while.
Some vibrations are felt	These vibrations or sound are caused by disc drive: This does not
or slight sound is heard	indicate a fault.				
from mechanism.
LCD screen is hard to	Has brightness of LCD screen been adjusted?				86
see.	Stop recording and adjust the brightness.
	Is the DVD Video Camera being used outdoors?
	Use the viewfinder. When using LCD monitor, adjust its angle so that				35, 37
	LCD screen is not exposed to direct sunlight.
Focus is not correct.	Is it difficult to use auto focus with your subject?				63
	Focus manually.
	Does “MF” appear?
	The DVD Video Camera is set to manual focus. Focus the subject				62
	manually, or release manual focus.
	Is the dioptre control correctly adjusted if you are using the
	viewfinder as a monitor?				35
	Adjust the dioptre control.
	In cases other than the above, set the power switch to “OFF”, and				48
	then set it to “	”, “	” or “	” again.

VQT0K98

154

322