Panasonic VDR-M70GC Removing and Replacing from/in Round DVD Holder, How to Remove Disc

12

Removing and Replacing from/in Round DVD Holder

English

How to Remove Disc

1 Hold the Round DVD Holder with SIDE A facing up. While pushing the two release levers in the direction of arrows (1) marked on holder, slowly open SIDE A of the holder in the direction of arrows (2), taking care not to drop the disc.

Release

levers 1

1

SIDE A mark

2

2

Do not open more than 90°.

90°

When the Hinge of Round DVD Holder Comes off

1 Push the hinged portion of the holder piece marked SIDE A with thumb and middle finger, and warp it in the direction of arrows (4).

SIDE A mark side 4 Hinged portions

Approx. 90°

2 Fit the hinged portion of the other holder piece into the warped hinge portion.

Note:

• Handle the disc carefully so that no scratch, dirt,

fingerprint or dust adheres to the recording/playback

surface.

• When not using the Round DVD Holder, store it in case:

Do not leave a bare holder as is.

• Be careful of drop or impact: If you drop the Round DVD

Holder, the disc may pop out.

2 Without touching the recording/playback surface, hold the disc edge and centre hole to remove it.

• Do not subject the Round DVD Holder to force.

Disc Cleaning

Use a soft, dry cloth to lightly wipe off any dust, dirt, etc. adhering to disc, as shown in the figure. Never use solvent. Do not use thinner, water, anti-static spray, etc. to clean disc.

Replacing Disc in Round DVD Holder

1 Open SIDE A of the Round DVD Holder, and replace the disc in the holder with the SIDE A mark or label surface facing up, taking care not to touch the disc surface.

	3
OPEN marks	SIDE A
	mark
SIDE A mark side	3
or label surface

2 Close SIDE A of the Round DVD Holder, and push it to lock the release levers at positions (3).

VQT0K98

70

Use soft cloth to clean from inner to outer circumference in axial direction.

238