Panasonic VDR-M70GC user service Using Remote Control, Viewing Subject through Viewfinder

●Using Remote Control

To operate the DVD Video Camera with the remote control, point it to the infrared receiver before pressing buttons. If it dose not work properly, do not forget the pointing to repeat the action. The remote controllable distance is up to 5 m.

￿￿	￿￿	￿￿	Infrared
			receiver
		m
		5
		.
		rox
		p
		p
		A

Note:

When using the remote control, make sure that the infrared receiver on DVD Video Camera is not exposed to direct sunlight or any intense light. If the infrared receiver is subject to light stronger than the infrared light from remote control, the DVD Video Camera cannot be operated by remote control.

•If there is an obstacle between the remote control and infrared receiver on DVD Video Camera, remote control may not be possible.

•Depending on the type of fluorescent lamp, the remote controller may not work properly.

English

Viewing Subject through Viewfinder

1 Pull out the viewfinder.

2 Turn the dioptre control knob to adjust the focus to suit your eyesight.

Dioptre control

Pull out the viewfinder.

Caution:

Do not lift the DVD Video Camera by holding the viewfinder or LCD monitor: If the viewfinder or LCD monitor comes off, the DVD Video Camera will fall.

8 : 0 0 AM S E P 3 0 2 0 0 4

Note:
• If no image appears in viewfinder, refer to “Check 6” on
page 144.
• If the LCD monitor is open approximately 90°, the
viewfinder will be off.
• Focusing will not be correct unless the viewfinder is
pulled out.	VQT0K98
	35

203