Panasonic VDR-M70GC user service Removing Disc

English

Removing Disc

1 Set the power switch to “OFF” to turn the DVD Video Camera off.

2 Press down the DISC EJECT lever once and release it.

In a moment, the cover of	￿￿￿￿￿￿￿￿￿
disc insertion block will
open slightly.

3 Gently open the cover until it stops.

When the cover is fully open, the disc will slightly come out from the disc guide, and stop.

4 Remove the disc.

Hold the top of Round DVD Holder as shown in the illustration and gently pull it out.

Note:

Be careful not to touch the disc exposed portion

when removing the disc.

When grasping the holder, avoid the disc exposed portion.

5 Gently push the section indicated “PUSH CLOSE” on the cover of disc insertion block, to close the cover.

Note:

•Even after the DVD Video Camera is turned on, the disc can be removed unless it is in recording status. Hold down the DISC EJECT button for approximately 2 seconds, and then release it to remove the disc (The DISC EJECT indicator on the LCD screen will blink.). It is recommended that you turn the DVD Video Camera off before inserting or removing disc to prevent misoperation.

•Do not remove the battery pack or disconnect the AC adaptor/charger during removal of the disc or until power is completely turned off: If you do, the disc cover will not open. If this happens, reattach the battery pack or AC adaptor/charger, push down the DISC EJECT lever once, and then release it.

•Do not insert anything other than the 8 cm DVD-RAM or DVD-R disc into the disc insertion block: Doing so could cause malfunctions.

•Set the power switch to “OFF” to turn the DVD Video Camera off.

•When inserting or removing the disc, be careful not to touch the inside of DVD Video Camera [especially, the lens of laser pickup (see “Terminology” on page 165 )].

•When inserting or removing the disc, connect a charged battery or AC adaptor/charger to the DVD Video Camera: The disc cover will not open unless the DVD Video Camera is powered.

VQT0K98

46

214