Technics SC-EH560 The radio preset tuning, Hold down SET, Tune to the required station, channel

Press [TUNER/BAND].

SET

TUNING MODE 2 4 3

A SET

MHz

B

SET

2

3 ? TUNING @

4 SET

C

HSLEEP PROGRAM CANCEL

			DISC
1	2	3
			j/-/--	2
4	5	6
7	8	9	0
3D AI EQ/M.EQ BAND
		EQ

CH SELECT			AV EFFECT
TEST	UPRO LOGIC	SUPER	DIGITAL
		SURROUND	S.WOOFER
VCR/AUX/	TAPE/	CD	TUNER/	1
6CH INPUT	DECK 1/2		BAND
	Ú/g
		ÛÈ￿	Û￿
MUTING	M N
				3
¶￿	VOLUME		µ￿

1 TUNER/ BAND

2	1	2	3		Preset channel
				j/-/--
	4	5	6
	7	8	9	0
3	¶￿		VOLUME		µ￿

The radio: preset tuning

Choose either automatic presetting, which presets all the stations the tuner amplifier can receive, or manual presetting, which allows you to select the stations to preset and the order they are to be preset in.

There are 39 channels available for presetting.

A	Automatic presetting
»
Do the following once each for FM and AM.
Preparation: Tune to the frequency presetting is to begin at
	(➡ page 16).
Hold down [SET].
Release the button when “AUTO MEMORY” appears.
The tuner presets all the stations it can receive into the channels in
ascending order. FM stations are preset into channels 1 to 39, and		operations
AM stations are preset into channels 21 to 39.
“SET OK” is shown when presetting is complete and the last station
to be preset is played.
“ERROR” is displayed if the tuner doesn’t receive any stations. Do
presetting manually if this happens (see below).		Basic
Note
AM stations replace any FM channels that were preset in channels
21 to 39.
B	Manual presetting
»
Preset the stations one at a time.
1 Tune to the required station.
2	Press [SET].
3 Press [TUNING (X or W)] to select a
	channel.
4	Press [SET].

The station occupying a channel is erased if another station is preset

in that channel.

»C Selecting channels

On the remote control

1

2 Press the numbered buttons to select the channel.

For channels 1 to 9 press the corresponding number. For channels 10 or over press [L], then the two digits. e.g. To select channel 21 [L]>[2]>[1]

3 Adjust the volume.

On the main unit

1Select “PRESET” with [TUNING MODE].

2Press [TUNING (X or W)] to select the channel.

17

RQT5355