Technics SC-EH760 Cassette tapes, Press DOLBY NR to select Dolby NR, Adjust the volume, Basic

operations

1 4 2 3 1

DECK 1/2	@
H/I	5

Cassette tapes

Preparation: Press [ê/I] to turn the unit on.

1 Press [< OPEN] on deck 1 or deck 2 and insert the cassette.

2 Press [DOLBY NR] to select Dolby NR

on (“ëNR” appears) or off. (➡ “Dolby noise reduction” page 19)

3 Press [REV MODE] to select the re- verse mode.

Each time you press the button: h: One side is played. d: Both sides are played.

f: Both sides are played 8 times each.

4 Press ["] (reverse side) or [!] (forward side). Play begins and the indicator changes to green.

5 Adjust the volume.

Basic

			To stop the tape
			Press [º].
1	EOPEN		[A] To change the deck to be used
		Forward side	Press [DECK 1/2] to select the deck you want to play.
		Tape facing down	To listen to 2 tapes consecutively
			Insert a tape into each deck and select “f”. Both tapes will be
			played 8 times each.
2	DOLBY NR		Cassette tape selection and care

	1	ë￿NR	The unit can correctly play the following types. It identifies the type
			automatically.
3			Normal position/TYPE I	✔
	REV MODE		High position/TYPE II	✔
	1	ë￿NR	Metal position/TYPE IV	✔

4

Tape direction

5 UPVOLUME

³Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.

³Tape slack can get caught up in the mechanism and should be tak- en up before the tape is played.

³Endless tapes can get caught up in the deck’s moving parts if used incorrectly. Use tapes appropriate to this unit’s auto-reverse mech- anism.

DOWN

A

DECK 1/2

2 ë￿NR

Deck in use

RQT5355