Using the Unit

{PUSH} mode (Push to talk mode)

1

2

When a ringer tone is heard, press {TALK}.

Speak to the visitor.

3 To end the conversation, press {TALK}. LThe display will turn off.

{AUTO} mode (Auto talk mode)

This mode allows you to answer the call by voice. Speak a brief reply into (or toward) the monitor station, such as “Yes?” or “Hello?”. This reply is used to start {AUTO} mode; the visitor will not hear your reply. The monitor station will beep to indicate {AUTO} mode has started and you may then speak to the visitor.

1

2

3

When a ringer tone is heard, answer “Yes?” within 30 seconds.

LA beep will sound to indicate that you can talk to the visitor (hands-free conversation).

Speak to the visitor.

To end the conversation, press {TALK}.

Note:

LMake sure you are within about 50 cm of the monitor station. LYou can also answer the call by pressing {TALK}.

LYour initial reply should be brief (less than 1 second), otherwise {AUTO} mode will not start.

LIf a visitor calls you, a loud, brief sound (such as a barking dog) may start {AUTO} mode even though you have not replied by voice.

{HOLD} mode (Hold to talk mode)

1

2

3

4

When a ringer tone is heard, press and hold {TALK} to speak to the caller. LA beep will sound and the Talking indicator will light.

To listen to the visitor, release {TALK}.

LThe Talking indicator will turn off.

To speak again, press and hold {TALK}.

To end the conversation, tap {TALK}.

Note:

LMake sure you speak to the caller only while pressing {TALK} and release {TALK} when you have stopped speaking so that the caller can speak to you.

32

Page 32
Image 32
Panasonic VL-G201 installation and operation guide Push mode Push to talk mode