A B
1
COUNTER
RESET DISPLAY DECK 1/2
6345 2
A
COUNTER
DISPLAY
COUNTER
RESET
C
| Side A |
Tab for side B | Tab for side A |
To | |
Normal tape | |
A | A |
| |
Discrimination hole
D
operations |
| 1 |
|
|
|
Recording |
| 2 | 3 | 1 | |
|
|
| |||
|
|
| <OPEN |
| Forward side |
|
|
|
|
| |
|
|
|
| Tape facing down | |
|
| 2 | DOLBY NR |
| ÎNR |
|
|
|
| 2 | |
| RQT6301 | 3 | REV MODE |
| ÎNR |
|
|
|
| 2 | |
Before recording (Deck 2 only)
See page 39 for tape selection.
Note
[EH780]
You cannot record when [6CH DISCRETE INPUT] is selected.
Volume, sound quality and surround effects have no effect on re- cording. Sound quality and surround effects are automatically set to flat when recording.
»A To display the tape counter while recording
Press [COUNTER DISPLAY].
The counter is displayed for about 5 seconds.
³Press [COUNTER RESET] to reset the counter.
³To display or reset the tape counter for deck 1, first press [DECK 1/2].
»B Erasing recordings
Press [INPUT SELECTOR] to select “TAPE”.
Insert the recorded tape into deck 2.
!Press [DOLBY NR] so the “ë NR” indicator goes out. " Select the reverse mode.
# Press [´ REC PAUSE]. $ Press ["] or [!].
»C Erasure prevention
The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown, being careful not to cover the high position discrimination hole.
Your attention is drawn to the fact that recording
»D Preparatory steps
Do these steps before each recording.
Wind up the leader tape so recording can begin immediately.
1 Press [< OPEN] on deck 2 and insert the cassette.
2 Press [DOLBY NR] to select Dolby NR on (“ëNR” appears) or off.
(á “Dolby noise reduction”, page 19)
3 Press [REV MODE] to select the reverse mode.
Each time you press the button:
>:One side only records.
@and B: Both sides record (forward >reverse).
“B” automatically changes to “@” when [´ REC PAUSE], [EDIT] or [TAPE EDIT] is pressed.
