Technics WX-H3050 manual ID Registration, Deletion of ID

SW#8: This switch selects RF Power.	• If ID registration is performed for 2 or more headsets,
ON: Reduce Power	follow the steps 2-4 individually.
OFF: Full power

■ID Registration

1.Press the ID Registration of the center module for 2 sec- onds or more. The system is changed to the ID Registration mode.

2.While holding down the T1 and T2 buttons simultaneous- ly, hold down the power button to turn on the headset. The headset enters the ID Registration setting mode where the indicators and buttons have different func- tions than in normal operation. You will hear "ID Registration Mode" and the power indicator will blink yel- low.

■Deletion of ID

To delete the registered ID of All-in-One Headset, follow the steps below.

1.Hold down the POWER button for more than 2 seconds to turn off the power of All-in-On-Headset.

Power button

Keep holding down

3.Press the T1 button, the headset searches for the center module. You can hear "Connecting center module A" and the lane Indicator will blink yellow.

*Press the T2 button (at double-drive-thru), for other cen- ter modules. You can hear "Connecting center module B" and the lane indicator will blink green.

When the ID Registration succeeds, you will hear "Registration complete" and the headset number, and the power indicator stops blinking and stays on.

4.When IDs are registered on all headsets, press the ID Registration button of the center module, ID registration mode is completed. The power indicator of the headset will change from yellow to green.

Notes:

•If ID registration fails, a warning sounds "beep" and then you will hear a voice prompt say "Failed". If registration fails, the ID is not registered and the "Power" indicator blinks red.

If this happens, turn off the power and try registering again.

•All-in-One Headset or Order Taker that can register in one center module is up to 32.

If you register IDs exceeding 32, the unused ID that has been registered is automatically deleted in chronological order.

2.To delete an ID that is registered for LANE A, keep pressing the T1 and C buttons simultaneously and start up the power of All-in-One Headset.

To delete an ID that is registered for LANE B, keep pressing the T2 and C buttons simultaneously and start up the power of All-in-One Headset. The power indicator then blinks in yellow.

Keep holding down (LANE A)

Keep holding down (LANE B)

3.Press the P button while the power indicator keeps blink- ing in yellow. The ID that is registered for LANE A (or LANE B) is deleted.

Keep holding down

4.The power indicator turns to blinking in red. A message of "ID is not registered" is heard from the All-in-One Headset speaker.

17