Operating the equipment correctly

Connect to power supply 230V/50Hz AC

The TV set is designed to receive and reproduce only sound and video signals.

The set is designed to be connected only to audio and video equipment, antenna installations and computers that comply with DIN standards, and carry a CE certification.

The set may be used for private and commercial purposes, and must be operated inside a dry room, and under supervision.

Any other form of operation is specifically exclu- ded.

Manufacturer’s declaration

This equipment complies with the following stan- dards:

Radiation (X-Ray) regulations (RöV in Germany) of 08.01.1987,

EU guideline 73/23/EEC (low-voltage regulations) - EN 60065

EU guideline 89/336/EEC (EMV guideline)

-EN 55013, EN 55020, EN 60555-2 And carries CE certification.

Disposal advice

Spent batteries should not be discarded with dome- stic refuse. They can either be disposed of by sepa- rate channels, or they will collected by the dealer.

Should the TV set reach the end of its lifespan after many years, specialist retailers will take it back for environmentally-friendly disposal

TechniSat provides a coupon for an old TV set when you purchase a new set.

Cleaning and care

The housing of a Colani-Line set can be cleaned with a soft, slightly moist cloth.

The housing of a Classic Line set can be cleaned with a soft, dry cloth.

Do not use spray cleaners or any aggressive chemi- cal detergents for the housing, as this may damage the high-quality surface.

The screen can be cleaned while the set is switched off, using a dry or very slightly damp cloth.

Initial Operation

Safety advice

If the following safety precautions are ignored, the manufacturer's responsibility ceases.

Never open the housing!

It is extremely dangerous to touch parts carry- ing high-voltage current.

Only trained personnel may carry out repairs.

Should the set be delivered or transported during cold weather, do not switch it on immediately, but allow the set to adjust to room temperature first.

Operate the set in an environment where it is safe from humidity and damp, as well as splashes or drops of water. If water gets into the housing, immediately disconnect the power supply and call a service technician.

Do not place the set in very confined bookshelves or cupboards, and allow at least 10cm space all round for ventilation.

Do not place the TV set near a heater or other equipment that will cause the set to heat up more than usual.

Do not expose the set to strong sunlight, and never cover up the ventilation slots, as this would affect the cooling of the set.

In case of electrical storms, disconnect both the antenna and power connections, as power surges can damage the set.

Do not stick any objects into or through the ventila- tion slots.

If you notice a specific defect, or if there is a stran- ge smell and smoke coming from the set, dis- connect the power supply immediately, and call a technician.

If you are out of the house for an extended period of time, the TV set should be switched off. This saves energy, and prolongs the lifespan of the pic- ture tube.

If the set is kept in standby mode via the remote control, power consumption is approximately 1 Watt.

2

Page 3
Image 3
TechniSat 100Hz Television sets Colani-TV Classic Line Initial Operation, Operating the equipment correctly