TechniSat DIGITY 1 manual Setting the switching matrix and the LNB properties, Additional settings

bed_anl_DIGITY 1_englisch_4.qxd 21.06.02 13:41 Seite 14

>Make adjustments in this line by means of the key OK DiSEqC on or off.

Since only one LNB can be addressed when the DiSEqC control is switched off, the menu is restricted to the configuration of a single LNB.

5.4.2Setting the switching matrix and the LNB properties

The menu lists the four switching criteria of the DiSEqC control.

Your receiver has been pre-programmed, so that ASTRA will be received in switch position A/A and Eutelsat in switch position B/A of a multiswitch. If the switching matrix of your recep- tion equipment be configured differently, or if it is set to receive other satellites, you can make the following settings/adjustments in your receiver.

> Use the arrow up/down keys dto select the DiSEqC switch position (1-4) that you want to allocate to a particular satellite (e.g. A/B 3 No Satellite), by marking this line in blue.

> Confirm by pressing OK.

A list of various satellites will now be displayed.

> Use the arrow up/down keys to mark the satellite selected.

The arrow up/down keys will move the marker up or down one line at a time, while using the Parrow left/right keys will jump to the previous or next page.

If the satellite you are looking for is not specifically listed, select one of the spare posi- tions, marked as User1 to User 14.

> Confirm by pressing OK.

The selected and marked satellite will now be inserted and shown at the previously marked position in the menu >Settings>LNB.

Continue to work your way through the Menu >Settings>LNB, until the data in this menu corresponds with that of your reception unit. Any switching criteria not required should be set to the position No Satellite.

5.4.3Additional settings

Now that you have adjusted the switching matrix of your DVB receiver to correspond with your reception unit, you should now check the additional parameters of your reception unit, and, where necessary, make further corrections.

>Use the arrow left/right keys to move the marker to the column LNB-Test.

>Now use the arrow up/down keys, to mark the field Continue.in the line in which you want to check or alter the settings.

>Confirm by pressing OK.

The menu >LNB>Check will now be displayed, showing the DiSEqC setting selec- ted (e.g. A/A 1).

The following settings may be made:

LOF low band

LOF (Local oscillator frequency) is the frequency used by an LNB to convert the frequency received into the so-called 1. Intermediate Frequency, which can then be interpreted by the

14