bed_anl_DIGITY 1_englisch_4.qxd 21.06.02 13:41 Seite 9
4 Connections
The various references below - a b c etc., refer to the diagram on page 8.
4.1 Mains connection
The receiver should be connected to the mains supply only after it has been connected to all other components in the system. This serves to avoid damage to both the receiver and to other components.
bOnce you have made all other connections, use the mains cable supplied to connect the receiver to a mains socket 230V/50Hz.
4.2 External unit
aConnect the LNB input of the receiver to the LNB of your external unit, using a sui- table coaxial cable. Note point 5 of the chapter on "Installation".
4.3 Connecting to a TV set
dConnect the receiver (SCART socket TV) to the TV set (SCART socket) by means of a SCART cable. If your TV set is appropriately equipped, it will switch automatically to AV, and thus to satellite reception, when the receiver is switched on.
4.4 Video cassette recorder (VCR)
cConnect the video player to the SCART socket VCR. During Play mode, the video player will send a switching signal to the receiver, and the Video player signal will automatically be sent to the TV set.
If your video player does not transmit a switching signal, use the EXTERN key of your receiver to switch it to the external input VCR. Pressing this key again will return you to normal operation.
4.5 Amplifier
In order to achieve the best possible sound quality, you can connect the receiver to a
4.6 Serial Interface RS 232
The RS 232 interface is used for
9
