bed_anl_DIGITY 1_englisch_4.qxd 21.06.02 13:41 Seite 15
receiver.
LOF high band
When this line is marked, use the numeric keys to enter the LOF frequency of the high band of your LNB.
Switchover LOF low/high
When this line is marked, use the numeric keys dto enter the frequency at which your LNB switches over from
Transponder test
The following points of this menu should only be entered if you want to test the satellite sig- nal by means of a
Transponder frequency
When this line is marked, use the numeric keys to enter a frequency on which digital pro- grammes are broadcast.
Polarisation
Use the arrow up/down keys to enter the desired polarisation plan (horizontal or verti- cal).
Symbol rate
The symbol rate expresses the volume of data transmitted per second. This could be, for instance, 27500 (27500 symbols per second). Use the numeric keys to enter the appro- priate symbol rate.
FEC Rate
Press the OK key to display a window, in which you can use the arrow up/down keys to select the desired FEC rate (1/2, 2/3, 3/4, 5/6, 6/7 or 7/8).
If you do not know the FEC rate, select Auto in this line. Press the OK key to accept this setting.
Signal
If you have entered the information relating to the test transponder correctly, this line will dis- play the signal strength.
6 Operation
6.1 Switching on and off
>Switch on the receiver by pressing the On/Standby key on the receiver or on the remote control unit.
>Pressing this key again will switch off the receiver.
>The receiver is now in standby mode.
6.2 Programme selection
6.2.1 Using the Programme up/down keys
>You can move up and down the programme list one slot at a time by pressing the Programme up/down keys on the receiveron the remote control unit.
6.2.2 Using the numeric keys
>You can use the numeric keys to enter the desired programme slot number directly.
15
