*M-Focus 2.6.95 14.12.1999 10:34 Uhr Seite 14
If the desired satellite has not been found:
>Press to set pointer to „Suche starten“ (start scan).
>Press to start again.
If, due to bad receive conditions, a satellite cannot be found using the automatic scan feature, you can search and store it manually (see 5.4), and proceed with the automatic scanning afterwards.
If you also use LNB input 2, you can assign it to a stored satellite.
5.6 Correcting all satellite positions
If none of your stored satellite positions is peaked properly, you may need to correct the current antenna position.
Use this option with extra care since it may shift the satellites to incorrect positions.
>Display the installation menu (see p. 8).
>Set pointer to satellite scan
>Press to set pointer to
>Press to select.
The „optimise skew“ feature is identical to the one described in chapter 5.4.
You can activate the automatic selection of the best receive position
>Press to set pointer to „Autofokus“
>Press to turn on.
satellite scan |
|
satellit Hispasat 1 | 30W |
channel Tdeporte | 12.149 GHz |
stored position | 4816 |
> antenna position | 4816 |
west limit | 4806 |
east limit | 5058 |
antenna control | LNB 1 |
optimise skew | 132 |
^/v/</>/MENU/OK/STOP
>
>
>
Call feature with OK.
Press OK to set pointer to antenna position.
Press to turn the reflector until you have found the best receive quality for the satellite set up above.
INDEX
For a description of how to select satellites which are not part of the
STOP
> | Press | . | |
|
|
| |
> | Press | OK | to confirm the message „Sure?“ |
> | Press | to return without saving. |
The stored position is finally used as the current antenna position.
If possible you should use a satellite with a poor receive quality to correct the positions of all satellites since this will be the most exact satellite to correct.
14