*M-Focus 2.6.95 14.12.1999 10:39 Uhr Seite 42
Error | Possible cause | Measures |
|
|
|
Some satellites have good others have a bad receive quality | incorrect skew setting | mount the polarizer according to the instructions and correct the skew |
|
| parameters (see 7.7) |
| outdoor unit trajectory adjusted incorrectly | consult a specialist to have the trajectory adjusted correctly |
| reflector is too small for the satellite | use a larger reflector |
|
|
|
The channels of a particular satellite have different receive qualities | The channels are broadcast at different power levels | use a larger reflector |
|
|
|
Some channels of a particular satellite cannot be received at all | your LNB is not apt to receive at such frequencies | Use a different LNB |
|
|
|
Some satellites and channels are missing in the list of satellites or channels, | the satellite positions have not been stored | store the satellite positions (see 5.4 and 5.5) |
resp. |
|
|
|
|
|
The receive quality of some satellites has become lower | the outdoor unit has moved | |
|
|
|
All satellite channels display“wavy lines“ | receiver transmits on a channel which is used for reception via antenna | change transmit channEl on the receiver (see 4.2) |
|
|
|
A channel that is received via antenna displays“wavy lines“ | receiver transmits on a channel which is used for reception via antenna | change transmit channel on the receiver (see 4.2) |
|
|
|
The picture is full of black and white points (“little fish“) | heavy rain or snow | remove the snow from the outdoor unit |
|
|
|
Sound ok.,no picture | you have selected a radio channel | switch to TV mode (see 6.5) |
| channel is encoded | connect adequate decoder (see 4.5) |
|
|
|
Picture ok.,no sound | television is set to mute mode | check the volume on the television set |
| receiver set to mute mode or volume to low | check the volume on the receiver (see 6.4) |
|
|
|
Channel picture or sound disturbed,though working ok.before | audio or video settings have been modified | set up channel again (see 7.7) |
| channel is encoded now | connect adequate decoder (see 4.4 „Decoder“) |
| channel is no longer broadcasting | no measures |
|
|
|
Some channels cannot be selected pressing PROGR | channels has been deleted | select channel (see 7.3) |
|
|
|
A connected decoder does not decode | key or SmartCard is not valid | Check the decoder’s instructions |
| wrong SCART connection | check the connections (see 4.5) |
| wrong decoder signal selected | correct the setting (see 7.6) |
|
|
|
42
